LS1046a OCRAM ECC

[sanspepin]

1. Is there a way to inject SBE or MBE ecc error for the ls1046a OCRAM?
2. Is the MBEE_MSK from the RSTRQMR register is related to the OCRAM?
   1. If  the MBEE_MSK is 0, the RESET_REQUEST_B will trigger on MBE error?

[yipingwang · Accepted solution]

In response to the above queries:

Is there a way to inject SBE or MBE ecc error for the ls1046a OCRAM?
NXP:SBE or MBE ecc error can be cleared but not injected for the LS1046A OCRAM. Refer note under section "7.2 On-Chip RAM memory controller (OCRAM)" of LS1046ARM_Rev3.

Is the MBEE_MSK from the RSTRQMR register is related to the OCRAM?
NXP:Yes, MBEE_MSK from the RSTQMR is related to any of the SRAMs inside the chip including OCRAM.

If the MBEE_MSK is 0, the RESET_REQUEST_B will trigger on MBE error?
NXP: Yes, It is fine if it remains set. If MBEE_MSK is =0 then while the system is running and encounters an MBEE event then the RESET_REQ_B signal will be asserted, which if it is connected to HRESET will cause a reboot.