JN5169 EVM and PER validation with Non Signaling Test Using IQxel-MW

1 Kudo

This document will address the JN5169 CMET setup and JN5169 connection setup with IQxel-MW. We also show the EVM and packet error rate results.

david_han · ‎04-09-2020

Hi Jason,

Thank you for this useful document. I just wondering if you can add more information in this application note.

1) what is the test option in CMET when you perform sensitivity and EVM tests?

2) how to config the IQxel-MW step-by-step for sensitivity test and for EVM test?

3) are there any special SW/Firmware needed for IQxel-MW to perform these 2 tests?

Thanks again.

Best regards,

David Han