error of s32k144's flash read and write

[shenlanzeng]

Hi,i'm debugging flash read an write,when i used "EraseAndProgram",single step is ok,but run at full speed ,it reset,would you help to find what the promble ,thanks! ps:  I  used external 5V to supply .

 

[danielmartynek]

Hi,

How did you define the .MyRamCode section?

Please try the default ram section using:

__attribute__ ((section(".code_ram")))   // place the function below into .code_ram section
void EraseAndProgram(void);‍‍

Regards,

Daniel

[shenlanzeng]

thanks for your help，i tried it ，but it reset all the same

[danielmartynek]

Hi,

Can you attach the project?

Regards,

Daniel

[shenlanzeng]

thanks for your help,do you have any example of bootloder under the MDK , thanks!

[danielmartynek]

Hi,

I'm afraid we don't.

Regards,

Daniel

[shenlanzeng]

How to use MDK to generate bin，i used MDK generate bin like that：

but it generates a folder

can you tell me how to generate bin under MDK,thanks!

[shenlanzeng]

thanks for replay，the problem has been solved！

[jinshuaixu]

Hi, friend

      Maybe you are not close interrupt before operate flash.you can try that close interrupt before erase flash section ,and open interrupt in the end.

[shenlanzeng]

Hi，

Thanks for your relplay，how do i use the register operation to close all the interrypts，and open the interrupts，i didn‘t find the relevant information！

thanks for your help！

[jinshuaixu]

#if defined (__GNUC__)
#define ENABLE_INTERRUPTS() __asm volatile ("cpsie i" : : : "memory");
#else
#define ENABLE_INTERRUPTS() __asm("cpsie i")
#endif

/** \brief Disable interrupts
*/
#if defined (__GNUC__)
#define DISABLE_INTERRUPTS() __asm volatile ("cpsid i" : : : "memory");
#else
#define DISABLE_INTERRUPTS() __asm("cpsid i")
#endif

[shenlanzeng]

hi，i have been closed all interrupt，then erase the flash ，and run at full speed，but the s32k144 reset again.

best regards！