S32G3 serial RCON

[XD]

Hi,

I am reviewing the serial RCON configuration. In the RMS32G3 manual, section 31.3.2.3, it mentions using RCON[7:8] to connect to the EEPROM. However, in AN13456 (S32G3 Boot Process), section 5.4, it states that the BootROM assumes the EEPROM is connected to RCON8 and RCON9. Could you please clarify this discrepancy?

Thanks,

XD

[Celeste_Liu · Accepted solution]

Dear @XD ,

Thanks for contacting NXP support. After reviewing the information, we confirm that you should follow the instructions in the RMS32G3 manual. The configuration mentioned in that manual is the correct one for your reference.
If you have any further questions, please don't hesitate to contact us.
Best regards,

Celeste