PF8200 OTP programming

[nelson_scheja]

I'm planning to use the PF8200 in a project, and I want to program the OTP values so that the embedded application does not need to setup everything every time. I read that it's possible to program these via I2C, but I cannot find any additional information for that. The datasheet just states "contact NXP".

So, how is the OTP programmed?

[reyes · Accepted solution]

Hi Nelson,

The PF8100 datasheet can be found in the following link: https://www.nxp.com/docs/en/data-sheet/PF8100_PF8200.pdf

The OTP programming specification or similar document is not released yet since this PMIC is a pre-production device. For additional information you need to contact your authorized distributor.

https://www.nxp.com/support/sample-buy/distributor-network:DISTRIBUTORS

Consult with your distributor, some of our authorized distributors can pre-program your PMICs with your desired OTP configuration before they send them to you. Some distributors can program the parts for a cost.

Have a great day,
Jose

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------