PF1550 Exit from SHIP mode

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

PF1550 Exit from SHIP mode

Jump to solution
477 Views
Simmatth
Contributor I

Dear Forum

 

I'm currently implementing the PF1550 to power an i.MX-RT1060 
For my application I would need to exit the PMIC 'SHIP' mode by using (pulling low) the 'ONKEY'.

The datasheet (Rev 7) got me confused as on page 24 in table 26 the following is stated: "BATFET open, no LICELL connected. VSYS = 0 V, only awake from ONKEY enabled." This gives the impression that this function is supported.

However, on page 75 it says: "The only way to exit from this mode is by a charger attach event. The state machine exits to the REGS_DISABLE state when this happens. A battery reattach can also be used to exit SHIP mode."

Does the PF1550 support exiting from SHIP mode by using the ONKEY? And is there a register to enable this perhaps?

Kind regards
Simone Matthys

Labels (1)
Tags (3)
0 Kudos
Reply
1 Solution
468 Views
TomasVaverka
NXP TechSupport
NXP TechSupport

Dear Simone,

ONKEY cannot be used to exit SHIP mode. To wake up from SHIP mode, you need to attach a charger or reconnect the battery. There is no register setting that enables ONKEY to wake the PMIC from SHIP mode.

Screenshot 2025-03-13 155042.png

BRs, Tomas

View solution in original post

0 Kudos
Reply
1 Reply
469 Views
TomasVaverka
NXP TechSupport
NXP TechSupport

Dear Simone,

ONKEY cannot be used to exit SHIP mode. To wake up from SHIP mode, you need to attach a charger or reconnect the battery. There is no register setting that enables ONKEY to wake the PMIC from SHIP mode.

Screenshot 2025-03-13 155042.png

BRs, Tomas

0 Kudos
Reply