JN5189

[liushuiwuqing]

I was using OM15080-JN5189, and the firmware was the factory firmware. When conducting the zgwui test with the nxp tool, no matter what instructions were sent, there was no response. I performed the operation according to the ttug.pdf file.May I ask how I should configure it or what firmware to flash?

[liushuiwuqing]

Thank you for your reply. I can use it now, but I can't find the file JN-AN-1244. Could you please give me the relevant link?

[mihai_ignat · Accepted solution]

Hello.
You can download JN-AN-1244 from here: https://www.nxp.com/webapp/sps/download/license.jsp?colCode=JN-AN-1244

BR,
Mihai

[sofiaurueta]

Hello,

Hope you are doing well.

Could you clarify what the "ttug.pdf" refers to? What is the process that you did to program the devices? Is there a specific guide or document you are following?

I would recommend checking out the following documents:

Zigbee 3.0 Getting Started

DK6 Production Flash Programmer User Guide included in the SDK files under this path: SDK\docs\DK6-UG-3127-Production-Flash-Programmer

Zigbee 3.0 IoT Control Bridge UserGuide under the path JN-AN-1247.zip\JN-AN-1247\Doc

Best Regards,

Ana Sofia.