As of February 2, 2026, the NXP MEMS Sensor products have been transferred to STMicroelectronics. For details on the transferred products, see this page. Please reach out to STMicroelectronics for further information.
Hi,
in datasheet I find that max difference between P1 and P2 must be 400kPa. Which is max pressure to I bring to P1 and P2?
Can I get 1 MPa at both inputs, on example?
OK, thank you, I will try with 10bar.
Hi Nicola,
I do not know this max static pressure. However, 1MPa is OK as long as the difference between P1&P2 is less than 400kPa (and P1>P2).
Best regards,
Tomas
PS: If this answer helps to solve your question, please mark it as "Correct". Thank you.
