Hi
Is there a way for me to control the state of the Sensor Measurement Interface (SMI) i.e. turn it OFF or ON when required or is it done by the firmware defined subroutines only?
Exploring this path for additional power savings if possible.
Thanks
Tushar
Solved! Go to Solution.
Hi Tushar,
This is handled by the TPMS_READ routines: the entire measurement chain is enabled at the beginning of the routine and disabled at the end. So when the program exits the routine, everything has been turned off.
Best regards,
Tomas
Hi Tushar,
This is handled by the TPMS_READ routines: the entire measurement chain is enabled at the beginning of the routine and disabled at the end. So when the program exits the routine, everything has been turned off.
Best regards,
Tomas