Flashing GreenVIP using S32 Flash Tool on S32Z2

[hneelabh]

Hi NXP Team,

I am trying to flash binaries to the S32Z280-594 EVK following the provided user guide. The guide does not explicitly mention the steps for flashing the S32Z using the S32 Flash Tool (S32FT). However, since the steps for the S32E are provided, I have been adapting those.

After putting the board into Serial Boot Mode, I successfully uploaded the target and algorithm for the hardware without any issues.

Screenshot from 2026-04-06 11-33-22.png

 

However, when I attempt to upload the files, I encounter an unexpected error.
Screenshot from 2026-04-06 11-36-21.png

Screenshot from 2026-04-06 11-35-34.png

Given the lack of dedicated steps for the S32Z family, I am unsure if my S32FT configuration is correct. Could anyone provide guidance or point out what might be going wrong?

References:

• I am following Section 9.3.2.2 (Flash using Serial Flasher over UART) of the UG_S32ZE_GreenVIP document.
• I have verified that the board jumpers are set according to Section 2.2 (Serial boot mode) of the S32Z280-594_UserGuide.

Thank you in advance for your help!

Regards,
Harsh Neelabh
Adv Projects - Visteon

[chenyin_h · Accepted solution]

Hello, @hneelabh 

Thanks for your post.

For flashing S32Z280-594, I suggest trying it the following way:

1.png

BR

Chenyin

[hneelabh]

Hi @chenyin_h ,

Thanks for the reply. I was able to flash the GreenVIP using the configurations which you provided and boot the EVK thereafter. 

image.png












Just out of curiosity, how do we determine the configurations of the hardware, and how do they depend on the software we are flashing?

Regards,
Harsh Neelabh

[chenyin_h]

Hello, @hneelabh 

Glad that the issue is solved.

Typically, it depends on the hardware differences, I suggest checking the corresponding schematic to check the type of different flash used.

BR

Chenyin