Hello，
now I am working with S32K314 ,using RTD_R21-11_6.0.0 ,
I had a test case , set in application, send command jump to boot
before jump to boot ,I will write DATA to Dflash ,
sometimes I will see the debugger show enter WFI, and the current is very low
Trace32 showing Running Sleeping,
is there any idea about this issue?
Hello @KidhRobin,
Your application entered recovery mode based on the PC address.
In RM Rev. 12, Section 32.12 “Recovery Mode Sequence,” you can find scenarios in which SBAF executes the recovery mode sequence.
Regards,
Daniel
Hello @KidhRobin,
Your application entered recovery mode based on the PC address.
In RM Rev. 12, Section 32.12 “Recovery Mode Sequence,” you can find scenarios in which SBAF executes the recovery mode sequence.
Regards,
Daniel
