Hello team,
I’m having some issues with my AUTOSAR LED blinking project.
I followed the HOWTOs to build the project, but I encountered some problems.
This is my AUTOSAR RTD Version :
When I configure the MCAL Port, I can’t set the pin status—it always stays at 0 no matter which pin I select.
Also, as you can see on the right side, there are many peripheral code generation errors.
Did I miss a step in the setup?
Hi
Did you configure the pin in Pins Tool?
After entering the correct PortPin Pcr, you will see the corresponding configuration in the Pins Tool.
Regarding the PortPin Pcr number, please refer to the answer in Mismatch between the PIN configuration
Best Regards,
Robin
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "ACCEPT AS SOLUTION" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
