FS23 SBC AUTOSAR R21-11 Version 0.9.0

[raghunandanreddy]

I installed FS23 SBC AUTOSAR R21-11 Version 0.9.0 on my DS3.5 environment, following all the steps mentioned in the Release Notes.

However the package is not showing up in the SDK.

Here are my setup details:

• Target board: S32K311

• RTD version: 3.0

• FS23 SBC AUTOSAR R21-11 version: 0.9.0

• Development Studio version: DS3.5

I’ve verified the installation path and followed all instructions from the release notes but the SDK still does not list the FS23 SBC component.

Could you please suggest any solution or update to make it visible in the SDK?

[Julián_AragónM]

Hi @raghunandanreddy,

The IP component of FS23 is not available in 0.9.0 package, it's recommended to use FS23 1.0.0 + RTD 4.0.0 instead.

In the 1.0.0 package, both the IP and MCAL components are available, as well as the example routine:

  

There was also a bug where FS23 package overwrites FS26 during update site generation process, which was later fixed on version S32K3xx_SBC_FS23_R21-11_1.0.0_DS_updatesite_D2402_updated_D250115.zip.

Best regards,
Julián