FS26 LDO Off Issue

[kjy106906]

Hello

I am using the FS26 and S32K358.

I am using the FS26's VLDO2 as the power supply for the MCU and the FS26's VLDO1 as the power supply for the CAN transceiver.

When the MCU is left in a state of CAN communication, the FS26's VLDO turns OFF, cutting off the MCU's power.

(This occurs randomly, approximately every 1 to 8 hours.)

The VLDO is restored only after the FS26's power supply is cut off and then restored.

This issue occurs on all boards, not just a single one, and does not occur when CAN communication is not in progress.

The status when the issue occurs is as follows:

Vpre 6V O

VDIG 1.6V O

VBOS 5V O

VLDO2 X

VLDO1 X

VCORE X

DFS is disabled via OTP.

I would like to know the current state of the FS26 and what causes this to happen.

[RafaR]

Hello kjy106906 

Good day!

Is the watchdog enabled?

What are the values of:

• FS_STATES
• FS_GRL_FLAGS
• FS_OVUV_REG_STATUS
• M_REG_FLG
• M_STATUS immediately after failure?

Have you checked if FS26 is not displaying any UV or OV flags?

Also could you share your M_STATUS?

I hope this information has helped you, please let me know if you need help with anything else.

Have a great day and best of luck.

[kjy106906]

@RafaR 

Thank you for the reply.

Unfortunately, the MCU is receiving power from the SBC, but communication is not possible because the VLDO is OFF.

You must cut off and resupplied the board power for the MCU to function.

The watchdog window is infinite.