Error status 6 in response to start/stop discover cmd

[anthony_asterisk]

During testing with PN7150, I started getting error status response to the start stop commands.

41 03 01 06

and

41 06 01 06

What is the meaning of the 06 error code?

Where can I find definitions of the error status codes?

What is the best way to recover when this error occurs?

[anthony_asterisk]

So NXP doesn't provide basic documentation on how to interface their products?  I have to pay the NFC forum $2500USD to be allowed access to the documentation for NXP's components?

This error mode isn't even covered by NXP's example drivers.  Should I perform a hard reset when this condition arises?

[IvanRuiz]

Hello,

You can also find the error code less explained in the User Manual The error code 0x06 means semantic error which is received when the NFCC or DH receives a Control Message in a state where that Control Message is not allowed.

Regards,

Ivan.

[anthony_asterisk]

Where in the user manual can I find an explanation of the status in the user manual? 

Also since these response come in response to a request to start/stop discovery, how can I determine the state of the rf management interface that does not allow discovery start/stop?

[IvanRuiz]

Hi Anthony,

It is only mentioned the error code, I read the description in NCI document.

Anyway, we recommend  that customers first start on our eval board with our corresponding software and once comprehended, move to a custom project.

Thank you for your comprehension.

Regards,

Ivan.

[IvanRuiz]

Hello,

For more information about status codes please refer to the NCI document available in NFC Forum after registration.

Regards,

Ivan.