Hello NXP Community,
I am currently working with a PN5190 Development Board and facing an issue while trying to establish communication between an external MCU and the onboard PN5190.
As per the documentation, I have already performed the R5 to R7 resistor replacement, which is required for external MCU interfacing. However, even after this modification, I am unable to establish communication between the external MCU and the PN5190.
Could someone from NXP or the community please advise:
If any additional hardware or jumper configuration is needed for external MCU communication.
Thank you in advance for your assistance.
Best regards,
Okay, we’ll continue in the internal ticket.
Hello,
We will continue the communication in your internal ticket.
Regards,
Eduardo.