Hi,
I have a question about the MLC #ASL5115SHN.
The CAN application protocol shown in figure 10 at 8.16 Application protocol, includes the cmd and MLC address in the extended ID frame.
But where do i write the register address to read/write a specific register?
And how do I know which cmd uses which register?
Hope you can help me.
Sandra
Hi Sandra,
Please refer to the MLC_CAN(FD)_commands_Reference_Manual.
This document is classified as a Secure File requiring an NDA.
If your company has not signed the NDA with NXP yet, you can request it from:
https://www.nxp.com/support/support:SUPPORTHOME
If there is a valid NDA in place, you can download it from the following website:
https://www.nxp.com/products/power-management/lighting-driver-and-controller-ics/automotive-lighting...
Please make sure you are signed in to nxp.com. If you do not see these documents, please click on "Request additional access" or edit your secure access rights by going to My NXP > Profile.
For more information about secure access rights, please refer to this website:
https://www.nxp.com/support/support/secure-access-rights:SEC-ACCESS
BR, Tomas