Flash problem on S32k344 (MBDT

[Paul50000]

I am working on s32k344 EVAL board (HV BMS). The problem is i am not able to flash my code through Simulink. I have created a simple DIO Led Blink model (Just ON the LED). the model was build, even the code is generated, No errors. Still the LED is not ON. When i used S32DS software to blink the LED. The LED is blinking. And then i tried to flash with Simulink. the LED went OFF. Means the program is flashing but the LED is not ON. I double checked the PIN PTA21(RED_LED). What am i doing wrong. I have installed the support packages for debugger and  MBDT Toolbox in MATLAB

[SorinIBancila]

Hello,

Did you configure the FS26 to enter debug mode? Otherwise, it will keep resetting the board.

If you are using the X-RD-K344BMU, you can check the included examples in the toolbox to see how to configure Dio, Port components to toggle the LED.

Best regards,

Sorin Bancila

[Paul50000]

How to configure FS26. I cant find documentation regarding it right now. Please help

[SorinIBancila]

Hello,

When powering up the board, keep pressing the SW1 button.

Do not forget to check the examples included in the toolbox, where you have a reference configuration for this board.

Best regards,

Sorin Bancila

[Paul50000]

i always press the button(SW1) when connecting with PE Micro debugger. But not while flashing or after flashing. I tried with S32 DS software seperately. It flash successfully and LED blinks but when do the same flashing with Simulink then it is not blinking or resetting

[SorinIBancila]

Hello,

Alright, so it is not a problem related to FS26.

If possible, can you share your model with me to have a look?

Best regards,

Sorin Bancila

[Paul50000]

I am sharing my file with you. Its just a basic LED model. Please check whats the issue

[Paul50000]

I have shared the files. Please reply