CodeWarrior 2.1 and CodeWarrior 10.6 PE Driver

[Yorn]

PE Driver(multilink_universal_install_12.2 ) can use on CodeWarrior 2.1 IDE ,but  it can not use on the CodeWarrior 10.7, it must instatll 12.7. Is PE Driver can used on the both CodeWarrior 2.1 IDE and CodeWarrior 10.7 IDE?

[petervlna]

Hello,

@stanish could you comment here?

Best regards,

Peter

[stanish]

Hi, 

I've just installed Drivers 12_7 on my Windows 10 64bit machine and use it with CodeWarrior for MPC55xx/56xx v2.10 and

• PEmicro Multilink FX (black probe) rev.C
• PEmicro Multilink PowerPC Nexus (blue probe) rev.

All configurations work as expected.

Do you observe any issue on your side?

If yes, can you attach the error screenshot?

Hope it helps.

Stan

[ArunMukundan]

Hi,

Could you please help me to resolve this error.

PFB is me driver details

The USB indication led is turned on and it is blue color. 

Still the software is not detecting the hardware.

[Yorn]

Hi,Thank you for your replying. My window is Windows 11 64bit , My drive and PE type is as following figure

 

When debuging on  CodeWarrior 2.10 using multilink_universal_install _12.7. It is not ok,

When debuging on  CodeWarrior 2.10 using multilink_universal_install _12.0. It is  ok,

[stanish · Accepted solution]

Can you try to install P&E patch available here:

https://www.pemicro.com/downloads/download_file.cfm?download_id=463

This should update the support for all compatible PEmicro interfaces into CW MPC55xx/56xx v2.10

Stan

[ZhaoDinan]

Hi 

Thank you, I solved the PEmicro recognition problem using the method above, but now I'm encountering the "load fail" issue.

when I clicked the "connect(Reset)"button ,the new problem was appeared as below. And how can I solve this problem ?(load aborted)

[Yorn]

IT is not found elf.file ,reload the elf file to the path

[ZhaoDinan]

Thank you!

[Yorn]

Thank you for your replying