I cannot use on the DCD tool an address that should be allowed.
It does not come up on the list of registers, but also blocks the manual entry, although the 1064RM specifies it as a valid address to be used:
Any information on why there is a restriction?
Solved! Go to Solution.
Hi,
Thank you for your interest in NXP Semiconductor products and for the opportunity to serve you.
In general, I replicated the error and I'll report this error to MCUXpresso config tool team in the next round of field trial.
Thanks again.
Have a great day,
TIC
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
Hi,
Thank you for your interest in NXP Semiconductor products and for the opportunity to serve you.
In general, I replicated the error and I'll report this error to MCUXpresso config tool team in the next round of field trial.
Thanks again.
Have a great day,
TIC
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------