push-pull output mode

[abyssnone]

Hello，Can the GPIO of MKE13Z be set to push-pull output mode? The manual only mentions push-pull output in the LPI2C section, but it is not mentioned in the Ports Summary.

[Celeste_Liu]

Hello @abyssnone ,

The GPIO of MKE13Z cannot be set to push-pull output mode. Only LPI2C pin can be configured to push-pull output mode. 

Hope it can help you.

BRs,

Celeste

[abyssnone]

How can I configure the I2C pins to operate in push-pull mode? thanks.

[Celeste_Liu · Accepted solution]

Hello @abyssnone ,

You can configure LPI2Cx_MCFGR1[PINCFG] bit to realize it.

Hope it helps.

BRs,

Celeste