How to Reset PHY in lwip stack

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

How to Reset PHY in lwip stack

1,526 Views
durgasivakrishn
Contributor III

Dear sir,

            i am using SDK_2.0_MK60DN512 stack provided by the NXP for Ethernet. I found that reset signal is required for PHY module to run it in FLASH mode. Can any one suggest, how to reset PHY in software.

With Regards,

Durga sivakrishna

Labels (1)
0 Kudos
Reply
1 Reply

979 Views
IvanRuiz
NXP Employee
NXP Employee

Hello,

Please refer to your PHY's datasheet in which you'll find a section of register description. You can communicate to the registers through the management interface (MDIO).

Best regards,

Ivan.

0 Kudos
Reply