How to Reset PHY in lwip stack

cancel
Showing results for 
Search instead for 
Did you mean: 

How to Reset PHY in lwip stack

671 Views
durgasivakrishn
Contributor III

Dear sir,

            i am using SDK_2.0_MK60DN512 stack provided by the NXP for Ethernet. I found that reset signal is required for PHY module to run it in FLASH mode. Can any one suggest, how to reset PHY in software.

With Regards,

Durga sivakrishna

Labels (1)
0 Kudos
1 Reply

124 Views
IvanRuiz
NXP TechSupport
NXP TechSupport

Hello,

Please refer to your PHY's datasheet in which you'll find a section of register description. You can communicate to the registers through the management interface (MDIO).

Best regards,

Ivan.

0 Kudos