AUT-N1891 Hands-On Workshop Programming of NXP's eXtreme Switch in Less Than 10 Minute

File uploaded by Lisa Hughes Employee on May 25, 2016Last modified by Renee Fortenberry on Dec 18, 2018
Version 3Show Document
  • View in full screen mode

During this course we will review how to use the new analog Freedom board FRDM-12XSF available for 12V eXtreme Switch devices thanks to the analog Processor Expert software and Kinetis Design Studio component. This training will cover full system enablement from hardware (MCU + analog), software (MCU agnostic) perspectives and demonstrate how to quickly drive different type of loads (resistive, inductive and capacitive). Thanks to its processor eXpert component, the interaction between MCU, sensor and our device will be facilitate, this training will cover different exercise to make the trainee fully enabled.

Outcomes