Motor Control Class: Commutation identification pattern (bonus video)

Video created by dumitru-daniel.popa Employee on Jun 11, 2017

    In this video we show the hall pattern identification procedure that can be applied to any motor in case you have no datasheet available. We will read the hall sensors outputs via the microprocessor and save the information for later use.

     

    We show:

    - How to prepare the Hardware setup

    - How to go over each identification table - row by row - to apply DC voltage and rotate the rotor in different sectors 360 degrees.

     

    NOTE: Chinese viewers can watch the video on YOUKU using this link

    注意:中国观众可以使用此链接观看YOUKU上的视频