Hi,
In the SPT 5.0 version, I extracted the fcb from the mcuboot image (Zephyr 3.1.0-release) and provided it as input in the userfcb option as below:
I get the error shown in the image above after uploading the user's FCB file.
Even with lower versions of SPT, they have the same problem as mentioned above.
Please advise on how to proceed with the "USER FCB".
Hi @vishnusudhankj ,
Thank you for your interest in NXP Semiconductor products and for the opportunity to serve you.
1) Please advise on how to proceed with the "USER FCB".
-- Actually, the error message already illustrates the cause, the fcb.bin missing some LUT commands.
Have a great day,
TIC
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
Hi @vishnusudhankj ,
Thank you for your interest in NXP Semiconductor products and for the opportunity to serve you.
1) Please advise on how to proceed with the "USER FCB".
-- Actually, the error message already illustrates the cause, the fcb.bin missing some LUT commands.
Have a great day,
TIC
-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!
- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------
