SN8000 and iMX6ULevk

gonfer · ‎11-25-2015

Hi all,

I’m trying to get a SN8000CMD module working on a iMX6ULevk but I’m facing some issues. The evk is running fsl-image-multimedia.

In kernel I’ve enable brcmfmac driver, as described here: https://wireless.wiki.kernel.org/en/users/drivers/brcm80211?s[]=bcm43362
In yocto I’ve added linux-firmare recipe
I’ve created /lib/firmware/brcm/bcm43362-bin.txt following this guide: http://wireless.murata.com/RFM/data/sn8000_sn8000ufl_nvram.pdf
Following this thread https://community.freescale.com/message/506774#506774 I’ve also checked:
- VDD_BAT and VDD_IO pin to be at 3.3
- VDD_3V3_EN to be 3.3V

dmesg related output is:

….....................

mmc0: no vqmmc regulator found

mmc0: SDHCI controller on 2190000.usdhc [2190000.usdhc] using ADMA

mmc0: queuing unknown CIS tuple 0x80 (7 bytes)

mmc0: queuing unknown CIS tuple 0x80 (6 bytes)

mmc0: queuing unknown CIS tuple 0x80 (8 bytes)

mmc0: queuing unknown CIS tuple 0x80 (2 bytes)

mmc0: queuing unknown CIS tuple 0x80 (7 bytes)

mmc0: queuing unknown CIS tuple 0x80 (5 bytes)

mmc0: new high speed SDIO card at address 0001

….....................

brcmfmac: brcmf_bus_start: brcmf_sdbrcm_bus_init failed -19

brcmfmac: brcmf_sdio_probe: dongle is not responding

brcmfmac: brcmf_ops_sdio_probe: F2 error, probe failed -19...

….....................

What am I missing? Any hints are appreciated !!

Regards,

Gonzalo

gonfer · ‎12-12-2015

any help, please??

gusarambula · ‎12-17-2015

Hello Gonzalo Fernandez,

Did you measure some signal of Enable pin and Reset pin of wifi module ? Please check your "WL_REG_ON" signal.

And how about your DTB configuration of Wifi relevant pin for this Murata wifi module ?