Hi @tobg ,
Hope you are doing well. You can use the shell example and perform DTM (Direct Test Mode).
For the DUT in transmitter mode, you could use the following command on DUT side:
- bt hci-cmd 08 34 00ff0002
For the reference device in receiver mode, you could use:
After completing the test, with the following command on both devices to stop the test:
For your reference, you can check this Application Note: https://www.nxp.com/docs/en/application-note/AN14163.pdf
Hope this helps.
If you have any question, please let us know!
Regards,
Ricardo