JN5168-001-M00Z Eagle Library

[tcoin]

Hello,

I have purchased a JN5168-001-M00Z module, and a would like to make a breakout board (breadboard friendly) in order to try this module.

I would like to know if you have the associated Eagle library (symbol and footprint) for this module.

Also, I would like to know if it is possible to use the LPC Link2 JTAG prog to debug it. If not, is there a cheap debug prog ? (I'm a hobbyist)

Thanks by advance

Thomas

[mario_castaneda]

Hi Tomas,

Please look at the Datasheet https://www.nxp.com/docs/en/data-sheet/JN5168-001-MXX.pdf 

Figure 5: Module PCB footprint

You could find the footprint that you are looking for.

Unfortunately, the LPC Link2 JTAG can not debug the JN5169 because it is a RISC 32 bits MCU, the LPC has not any information about the registers. I could recommend using the terminal to debug your application.

Sorry for the inconvenience that this may cause you.

Regards,

Mario