FXOS8700CQR1 IC marking

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

FXOS8700CQR1 IC marking

1,229 Views
felicita
Contributor II

Hi all,

We designed our sensor board with KL46 and FXOS8700CQR1(Acc+Mag) and FXAS21002CQR1(Gyro). We got the boards working but with little accuracy issues.

We have again designed our sensor board with KL17 and FXOS8700CQR1(Acc+Mag) and FXAS21002CQR1(Gyro) following all PCB guidelines as recommended.

The observed issue is as follows:

Unfortunately, in our new boards (10 nos), magnetometer is not getting calibrated.

The new boards were assembled with magnetometer with IC (bought very recently) marking

263

8700

ENA

The same boards started working when the magnetometer was replaced with older stock (about an year old) with IC marking

263

8700

DOC

Does the marking on IC mean any version change?

It will be greatly helpful if someone can assist us in solving this issue.

Thank you!

Regards,

Felicita Mercy D.

Tags (1)
0 Kudos
1 Reply

708 Views
david_diaz
NXP Employee
NXP Employee

Hello Felicita,

I assume the difference that you mentioned is in regard with the Errata for FXOS8700.

You may find more information at the link below:

Errata for FXOS8700

 

I hope this information helps.

Regards,

David

0 Kudos