hello,
i use the MR-CANHUBK344 development board with a segger jlink, and i have the same problem of this post
https://community.nxp.com/t5/S32K/S32K344-RTD-PORT-DIO-and-Debugging/td-p/1693264
is the jumper JP1 must be remove to program the board ?
i tried
r0
erase
but it don't work
the file .elf is the demo MR_CANHUBK3_IEEE1722
here the message
Connecting to target via C2
ConfigTargetSettings() start
ConfigTargetSettings() end - Took 24us
InitTarget() start
Unknown SDA AP Id detected: 0xFFFFFFFF
InitTarget() end - Took 2.62ms
Connect failed. Resetting via Reset pin and trying again.
ConfigTargetSettings() start
ConfigTargetSettings() end - Took 13us
InitTarget() start
Unknown SDA AP Id detected: 0xFFFFFFFF
InitTarget() end - Took 1.97ms
