S32 Design Studio 3.5 +Flashing issue when try to program through OPEN SDA

[nkarthik]

I am  facing flashin issue when try to  program through OPEN SDA

[nkarthik]

Hi Nxp team,

Can you please add Guideline doc's or checklist in the SW installation about the list of .dll needs to be whitelisted in the Antivirus.

Thanks Regards

Karthik.N

[Senlent]

Hi@nkarthik

I sent you a document via private message.

This document records the complete process of installing the development environment.

If this document still cannot solve your problem, then I don’t know how to solve your problem.

[nkarthik]

Target selected and Port is not detected

[nkarthik]

Hi Senlent,

 Please find attached document related to steps.

[Senlent]

Hi@nkarthik

please select a right target device in the highlight button and then try again.

[nkarthik · Accepted solution]

Hi Senlent,

 Thank you for the extended support. I am able to flash now.

Root cause : Antivirus block the NXP-S32Ds SW .dll.

[nkarthik]

Hi,

I am not able to select device and port

[Senlent]

Hi@nkarthik

please check whether the plug-in has been installed correctly.

[nkarthik]

Already installed PE-micro-Debug and working.

[nkarthik]

PE-Debug is installed and still the issue is not resolved

[Senlent]

Hi@nkarthik

If your problem is not solved, please still record the steps you took, otherwise I will not be able to help you analyze and solve it.

[Senlent]

Hi@nkarthik

could you please record the steps when you programming, so that i could help you troubleshooting the possible causes.

take a look at this post which may useful to you.

https://community.nxp.com/t5/S32-Design-Studio/Cannot-run-program-quot-gdb-quot-Launching-failed/m-p...

[nkarthik]

hi Nxp Team,

 Here is the flashing issue  snapshot and EVL Board (Power connected).please help to resolve this issue

[Senlent]

Hi@nkarthik

Let me double check it with you that you already can select target device?