Hello, I am trying to program the S32K148 without creating a complete IDE based project. My firmware engineer writes the code and sends me an executable. I recall there is a separate tool for only programming but the low end PE micro tool offers nothing and I can't find the programmer on NXPs site.
Update, I did find the program tool from PE for another $199. Wish I had just bought the Seggar.
Hello,
Yes, Segger would be good for it.
Eventually you can install S32DS and load the binary via it.
I can't find the programmer on NXPs site.
We do not have any programming tools.
You can have a look at some other supported tools like Lauterbach, iSystem, PLS, GHS, Segger... etc..
Best regards,
Peter