Hi Folks,
Is that possible to run open-plc-utils on stm32k344 board.
I have RTOS running on my board. I need to run open-plc-utils. Can you please give me an idea, how can I get started?
Regards
Ashok
Hi @VaneB ,
Thanks for the quick information. Yes, I want to run open-plc-utils on S32k344.
I will go through the document which the one you have shared with me in earlier message. If I require any suggestions I will get back to you.
Hi @ashokKumar5nxp
Correct me if I'm wrong but what I understand you are looking for is run open-plc-utils on an S32K344.
The information we have available is the following but the platforms that support are listed in Table 4. Supported NXP platforms.
Open Industrial User Guide
B.R.
VaneB
never-displayed
