Error in SIUL2

[Vamsi421]

Hi,
In my project i am using both MCAL and Ip drivers for interfacing with other driver. For this i configure many  pins  but my Siul2_Port_ip_Cfg.h showing only two pins as configured . Detailed information is provided in the below attachments and give me suggestions for using both drivers in the same project.
Thank You. 

[Vamsi421]

Hi @Julián_AragónM,
I am using S32 Design Studio 3.5
* Autosar Version : 4.7.0
* Autosar Revision : ASR_REL_4_7_REV_0000
* Autosar Conf.Variant :
* SW Version : 3.0.0
* Build Version : S32K3_RTD_3_0_0_D2303_ASR_REL_4_7_REV_0000_20230331

[Julián_AragónM · Accepted solution]

Hi @Vamsi421,

Is it possible to share you .mex file in order to test this on my side? Also, please share the SW version you are using.

Best regards,
Julián

[Vamsi421]

Can you provide me with some introductory tutorials and demos about AUTOSAR on the S32K3x series platform?

[Julián_AragónM]

Hi @Vamsi421

There is the S32K3xx Basic Bring-Up for AUTOSAR MCAL and Real-Time Drivers (RTD) Based on EB Tresos - Training,. It is based on EB Tresos but it goes over Autosar MCAL overview and configurations.

You can also look into the "Training Presentation" section under Documentation from the S32K3 Auto General-Purpose MCUs page for some other training presentations with different modules.

Best regards,
Julián 

[Vamsi421]

Hi @Julián_AragónM ,
The link you provided is not working 

[Julián_AragónM]

Hi @Vamsi421,

I can see both links working properly. Could you confirm which one is not working on your side? 

Also, even if the direct link to the presentation is not working, you can simply navigate to the S32K3 product page (S32K3 Auto General-Purpose MCUs) and scroll down to "Documentation". There, you can find the relevant presentations and trainings.

Best regards,
Julián.

[Vamsi421]

Hi @Julián_AragónM ,

I need to start with Autosar but i didn"t know how to start with autosar. Can you  please help me in this?
Thanks in advance. 

[Julián_AragónM]

Hi @Vamsi421,

As I've mentioned in the previous replies, you can use the documentation from the S32K3 Product page. I've attached some basic training presentations, and you can also refer to the following example in community: HOWTO: Create a Blinking LED example project using S32K1xx RTD with AUTOSAR - NXP Community. It is based on K1, but the procedure for creating a project is the same for K3.

If you have any other specific questions, please create another community thread. 

Best regards,
Julián