Error in C40_IP Peripherals Drivers in s32 Design Studio

[Ajay_R1]

I am using S32 Design Studio Platform IDE 3.5 for NXP S32K324 target board. 

I have created a new project with C40_IP Driver from my laptop and I am able to build successfully on my Target Board.

Same project, I shared it to one of my colleague,  it is not working for him and it was throughing error. Finally we cross verified all the software installed(like RTD, Development  package and S32 platform package)on our laptop.

For both of them it was same. But there is a difference in C40_IP driver where I have C40_IP Configuration while my colleague has C40_IP Driver. Please find the attachment, for your reference.

The below screenshot has taken from my Laptop.

Below Screenshot has taken from my colleague Laptop.

Regards,

Ajay. R

[DiaDev]

Hi,

I am currently working on the S32K311EVB board and facing an issue with the C40_Ip configuration. I have reviewed the available documentation, but I’m still encountering difficulties setting it up correctly.

I’ve attached relevant images/screenshots that illustrate the problem I’m experiencing.

Can provide guidance on the correct configuration steps for C40_Ip on this board?

Any support or suggestions would be greatly appreciated.

Thank you!

Best regards,

[Julián_AragónM]

Hi @Ajay_R1,

The Fls Driver has been replaced by Mem_InFls/Mem_ExFls to comply with AUTOSAR R21-11. Since NXP still provides the old Fls, Eep and Fee Drivers in parallel, some RTD versions still have these drivers.

Could you share which RTD versions you and your colleague are using?

Best regards,
Julián

[Ajay_R1]

Hi @Julián_AragónM ,

I have mentioned the versions in below which we are using.  

S32 Design Studio Platform Package Version 3.5.11

S32K3XX development Package, Version 3.5.8

S32K3XX.P01 RTD AUTOSAR R21-11 VEERSION 3.0.0

S32K3XX RTD AUTOSAR R21-11 VEERSION 3.0.0

The below screenshot has taken from my laptop

The below screenshot has taken from My colleague laptop

If you are required more details please let me know.

Regards,

Ajay. R

[Julián_AragónM · Accepted solution]

Hi @Ajay_R1,

You can update your RTD versions to the latest release for RTD 3.0.0 (P10) which include the Mem drivers, or downgrade to RTD 3.0.0 (without patch) for compatibility with the working project. You can look into the release notes for each version to see if these drivers are supported:

Best regards,
Julián