EMIOS counter bus configuration issue

[sbidkar]

Hello experts,

I configured .mex file for controller S32K342 with RTD 7.0.0.
I am getting following error:

I copied the configuration from S32K344 configuration with RTD 6.0.0 (because pin configuration and Peripherals configuration are same).

I put all the counter bus correctly which we require.
few screenshots for Emios_Mcl_Ip

 

Thanks.

[danielmartynek]

Hello @sbidkar,

Can you please share the .mex file?

Thank you

[sbidkar]

Please the refer the configuration shared.

Thanks.

[danielmartynek]

Thank you for the project.

I copied the .mex file into one of my projects and, interestingly, I don't see any errors when generating code from it..

Could you please clarify what you mean by: "I copied the configuration from an S32K344 configuration with RTD 6.0.0"? Did you copy the .mex file from a project that was originally created with RTD 6.0.0?

Regards,

Daniel

[sbidkar]

Thank you for quick response.

No, I did not copy entirely. I created new project with choosing 342 controller and copied the peripheral configurations. Not the whole project.

Hope this helps.

Thanks.

[danielmartynek]

Hi @sbidkar,

Last time, I opened the .mex file in S32 Design Studio 3.6.9 with RTD 7.0.1, and the issue did not occur. When I tested it in S32 Design Studio 3.6.5 with RTD 7.0.0, I was able to reproduce the issue.

Which IDE version are you using?

I haven't found an existing report for this issue yet. I'll check with the IDE team and get back to you.

Thank you,

BR, Daniel

[sbidkar]

Thank you, Daniel, for your response.

I am using IDE version 3.6.4

BR.