FAQs
English (US) 日本語 | Japanese 中文 | Chinese (Simplified)

S32K312 Development Board Debug Probe Selection.

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

S32K312 Development Board Debug Probe Selection.

Thursday
37 Views
NPD_SCTSPL
Contributor I

Dear NXP Community,

I am using an S32K312 (100-pin HDQFP) on a custom controller board with a 10-pin JTAG interface for programming/debugging.

I understand from some forum discussions that the S32 Debug Probe may not support S32K312.

Can anyone confirm whether the PEmicro U-MULTILINK can be used to program/debug the S32K312 through the JTAG interface?

Any guidance on a Cost effective and suitable debug probe would be appreciated.

Best Regards,
Fayas
SCTSPL, Bangalore

0 Kudos
Reply
1 Reply

yesterday
5 Views
VaneB
NXP TechSupport
NXP TechSupport

Hi @NPD_SCTSPL 

Actually, support for S32K3 devices was added relatively recently to the S32 Debug Probe. When using this probe, please note that it supports target system voltage levels only in the range of 1.2 V to 3.3 V. Therefore, VDD_HV_A must be configured to 3.3 V in order to establish a proper debug connection.

On the other hand, PEMicro debug probes have supported S32K3 devices for a longer period and have been widely used throughout the development and validation of many S32K3 software. As a result, a significant portion of the available application notes, getting-started guides, and example projects have been developed and tested using PEMicro tools.

Finally, regarding your question about the compatibility of the PEmicro U-MULTILINK with S32K3 devices, the answer is yes. PEmicro U-MULTILINK support S32K3 devices and are currently listed among the supported devices on the corresponding product pages of our website (Universal Multilink Development Interface | NXP Semiconductors).

 

BR, VaneB

0 Kudos
Reply