Hello,
I use the following macro 'REBOOT()' to restart an S12X system which has a permanently running XGATE thread:
#define STOP_XGATE() {XGMCTL=0x2020; while(XGMCTL_XGDBG==0); XGCHID=0;}
#define REBOOT() {STOP_XGATE(); __asm sei; COPCTL = 0x41; ARMCOP = 0x01; for(;
;}
The COP vector points to the startup code:
VECTOR ADDRESS 0xfffa _Startup
Most of the time it works, but sometimes the system restarts again (after one or two seconds). Could this be a problem with the macro above?
Thanks in advance,
pittbull
I use the following macro 'REBOOT()' to restart an S12X system which has a permanently running XGATE thread:
#define STOP_XGATE() {XGMCTL=0x2020; while(XGMCTL_XGDBG==0); XGCHID=0;}
#define REBOOT() {STOP_XGATE(); __asm sei; COPCTL = 0x41; ARMCOP = 0x01; for(;
;}The COP vector points to the startup code:
VECTOR ADDRESS 0xfffa _Startup
Most of the time it works, but sometimes the system restarts again (after one or two seconds). Could this be a problem with the macro above?
Thanks in advance,
pittbull
Hi again,
The problem is gone. Those macros were definitely *not* guilty
The problem is gone. Those macros were definitely *not* guilty
