EasyEVSE EV Charging Development Platform (FreeRTOS, Wi-Fi 4)

[Tomy61410]

Hi

I would like to ask about EasyEVSE EV Charging Development Platform. My question is that, if I only want to simulate the ISO 15118-based packet exchange between the EVSE and the EV, and then test other related functions after the simulation is successful, do I only need to use one of the MIMXRT1060-EVK/MIMXRT1060-EVKB/MIMXRT1060-EVKC or MIMXRT1064-EVK development boards as the main MCU, and one of the EVSE-SIG-BRD1X or 1 x EVSE-SIG-BRD2X development boards as the PLC signal board to complete the simulation of the packet exchange between the EVSE and the EV?

Best Regards

Tomy

[Tomy61410]

@Gavin_Jia, Thanks for your help!!!

[Gavin_Jia]

Hi @Tomy61410 ,

It is not enough. Please refer to this online document: https://www.nxp.com/document/guide/getting-started-with-the-easyevse-ev-charging-signal-board:GS-EVS...

Best regards,
Gavin

[Tomy61410]

Hi, @Gavin_Jia 

I have entered the code into the MIMXRT1064 EVK board and the EVSE-SIG-BRD2X board, and  preparing to connect the EVSE and EV to test packet transmission on both sides. However, I encountered a problem because I do not have the CLEV6630ARD NFC board and the RK043FN02H-CT 4.3-inch TFT 480*272 LCD touch display etc. Therefore, the EVSE side is experiencing a "no connection to RK043FN02H-CT 4.3-inch TFT 480*272 LCD touch display" issue, causing the EVSE code to get stuck(as the image below). I would like to ask if there are any other solutions besides modifying the entire code (which requires many changes and could have a chain reaction in code) and purchasing all the necessary equipment?

Best regards,
Tomy