Correct entry point for MPC5777C

[lucas_santos]

Dear All,

Please,

I am developing a software for MPC5777C, compiling with WindRiver Diab Compiler 5.9.6 and debugging with iSystem winIDEA iC5000.

I am having trouble in downloading and run my program. Everytime I try it goes to some FFFF address, however my program is in RAM memory 0x4000000. 

Does anybody know how to setup the debugger to go to my entry point?

Best Regards,

Lucas

[martin_kovar]

Hello,

this is rather question to iSystem or Windriver, because entry point is purely software dependent. Could you please try to ask at iSystem support?

iSYSTEM - SUPPORT 

Regards,

Martin