iMXRT 1024 evk debug error

cleo

Hello,

We are trying to debug a Secondary bootloader for IMXRT 1024 using the iMXRT 1024 evk board and MCUXpresso IDE. Whenever the debug session is launched, we get the following error:

cleo_0-1787762322632.png

============= SCRIPT: IMX93_connect_M33.scp =============

IMX93 M33 Connect Script

Reset pin state: 01

DpID = 0BD11477

TAP 0: 0BD11477 Core 0: M7 APID: 04770041 ROM Table: E00FD003*

APID = 0x04770041

Error: Wire Ack Fault - target connected?

m = 0x04770041

n = 0x04770041

... reconnect to see M33

DpID = 0BD11477

APID = 0x04770041

... disables the ECC logic for Cortex-M33 TCM

... disables the ECC logic for Cortex-M33 CACHE

Error: Wire Ack Fault - target connected?

... send a request to EdgeLock secure enclave to release the Cortex-M33 TROUT

... check

Error: Wire Ack Fault - target connected?

Resp1 : 0x000000C8

Error: Wire Ack Fault - target connected?

Resp2 : 0x000000C8

Error: Wire Ack Fault - target connected?

SCR = 0x00000000

M33_CFG = 0x00000000

TAP 0: 0BD11477 Core 0: M7 APID: 04770041 ROM Table: E00FD003*

M33 kicked off

Error: AP not ready

Error: No Halt Confirmation

============= END SCRIPT ================================

following reset read of core registers failed - Ep(08). Cannot access core regs when target running.

Target error from Commit Flash write: Ep(08). Cannot access core regs when target running.

GDB stub (C:\nxp\LinkServer_25.6.131\binaries\crt_emu_cm_redlink) terminating - GDB protocol problem: Pipe has been closed by GDB.

What is the cause of this issue? Hoe can it be fixed?

mayliu1

Hi @cleo ,

Thank you so much for your interest in our products and for using our community.

I don't think this issue is caused by the secondary bootloader itself.

From the debug log, it appears that MCUXpresso IDE / LinkServer is running the following connect script:

IMX93_connect_M33.scp

IMX93 M33 Connect Script

This script is intended for the Cortex-M33 core on i.MX93 devices. However, the i.MX RT1024 is a single Cortex-M7 device and does not use the i.MX93 M33 connection flow.

Could you please try below?

1: In MCUXpresso IDE, delete the existing debug launch configuration for this project.

2: Confirm that the project MCU/board is configured for an i.MX RT1024 device (or RT1024 EVK), not an i.MX93 device.

3: Open the launch/debug configuration and verify that the selected device/core is RT1024.

If possible, You can also share a screenshot of the Debug Configuration settings for further review.

Wish it helps you

Best Regards

May