Hi NXP,
I have a problem with S32DS.
The following steps could let me enter debug mode and using single step to trace my code well.
Run -> Debug config -> Debug
When I use "Run -> Run as" there are two options Local c/c++ application and S32DS c/c++ pplication.
I select one of them the another window shows C local application and then I select OK.
As show following figure:
The new window shows "Launch MPC5744-Uart_with_DMA-S32DS.elf" has encountered a problem.
As show following figure:
I don't know how to solve this problem. Does somebody give me a help?
Thank you very much.
解決済! 解決策の投稿を見る。
Hi Jeff,
functionality of this button is not implemented correct. Please use only Debug button to run your application.
Regards,
Martin
Hi Jeff,
functionality of this button is not implemented correct. Please use only Debug button to run your application.
Regards,
Martin
Hi Martin Kovar,
According your instruction uses Debug button, I can run code in debug mode and Free run mode.
Thanks for your help.
Best regards,
Jeff
Hi Martin Kovar,
Thanks for your reply.
Could you give me some steps about "Debug button" ?
Are there any other settings missing?
Best regards,
Jeff