How to change the memory model settings in an existing project

[maxxu]

Hi，

I use s912zvml64 chip to design the driver,With the increase of functions, the code is greater than 16K, and the original setting causes an error

I want to change the memory model from small to medium，How to set codewarrior11? Thank you

[StanoA]

Hi Maxxu,

In the CW_11.1 I strongly suggest you to use new project with new memory model.

Just select: File->New->Bareboard Project, put name of project, then select MCU Type ZVML64, and you will reach the page

Then select LARGE memory model and put your routines into this new project.

I think it will help you to solve your task.

Best Regards,

Stano.

[maxxu]

Hi Stano

   thank you，Whether the code warrior11 must have a license. When the code is greater than 16K, because when the memory model is set to medium, the selection page of math and motor control library is missing，If I don't have a license, can I debug more than 16K of code

[StanoA · Accepted solution]

Hi Maxxu,

The CW_11.1 Special Edition is free and you can build up to 64kB of code:

https://www.nxp.com/docs/en/brochure/BRCWPPI.pdf

You can download it from web:

https://www.nxp.com/design/software/development-software/codewarrior-development-tools/codewarrior-l...

I think it can help you to solve your task.

Best Regards,

Stano.