H,
i have MK10FN1M0VLQ12 .
is it possible use Ulink Programmer ? or any thing else universal programmer ?
thanks.
Hello mahdi shojaei
Yes, it is possible to use the ULINK debugger with the kinetis k10 since the MCUXpresso IDE supports this tool.
Also, you can check our recommended debuggers at the tab "Tools&Software" on this page Arm Cortex-M4|Kinetis K10 120 MHz 32-bit MCUs | NXP. These suggestions can be the P&E Universal Multilink or the LPC-Link2.
Let me know if this is helpful, if you have more questions do not hesitate to ask me.
Best regards,
Omar
Thank you Omar Anguiano .