I2C pinout error

[jirikuba]

Hello guys,

I have found an error in the datasheet for FRDM-KL25Z. It is regarding to I2C bus on pins PTE0 and PTE1.

In FRDM-KL25Z User's Manual (Rev 2).pdf can be found a picture with pinout stating that pin PTE1 is positioned on header J2 pin 20 and PTE0 is positioned on header J2 pin 18. So far so good.

However in FRDM-KL25Z Pinouts (Rev 1.0).pdf is written that that pin PTE0 refers to I2C1_SDA and is positioned on header J2 pin 20 and pin PTE1 refers to I2C1_SCL and is positioned on header J2 pin 18. It is not correct, SCL and SDA are SWAPPED!

I see that it is correct on FRDM-KL26 board, so somewho should fix it for FRDM-KL25. I was not able to find direct contact from NXP.

Regards,

Jiri

[Robin_Shen]

Hi Jiri,

Sorry for our document issue may bring any inconvenience to you. I will contact documentation team to update it in next version!

Best Regards,

Robin

[jirikuba]

Hi Robin,

Thank you for letting me know. I have built a board based on incorrect datasheet so I have to manufacture it again, not too painfull but still about £150 loss. Have you considered a little reward for discovering the error? What about one free FreedomBoard - they are awsome, I am big fan!

I am very pleased to hear back from NXP, it was little bit hard to figure out where to submit my finding.

Best regards,

Jiri