HCS08 TIM simulation problem

[joerg]

Hi
I try to simulate the output compare function for TIM1 of GB32/60, RC8 and QD4 MPUs.
But in the simulator the TIM does not trigger an interrupt. If i connect a MPU with the BDM it works just fine. The simulation of a TOF interrupt works in the full chip simulation. Is this a known problem (i noticed this behavior for CW3.1, CW3.2, CW5.0 and CW5.1!!)

Thanks Joerg

Message Edited by joerg on 2007-01-0112:30 PM

[CrasyCat · Accepted solution]

Hello

You need to submit a service request  for that.

This is an issue in P&E simulation module.  You can log that defect either with Freescale support or

directly with P&E.

To log the issue with Freescale please go to following URL:

    http://www.freescale.com/webapp/sps/site/homepage.jsp?nodeId=054670&tid=FSH

and click on "Submit a service request"

To log the issue with P&E use following URL:

  http://www.pemicro.com/support/index.cfm

Note that Freescale support personal will anyway have to log that with P&E.

CrasyCat

[joerg]

Thanks CrazyCat
i have put the service request on the freescale support page:

ID: 1-335781881

Saluti Joerg

[Phoenix]

This bug will be fixed in v5.2 update patch. It should be released at the end of January.