How to Program using BDM ?

[Pal]

So Far, I have been using the Code Warrior to code and then use the USB-BDM to program the micom.

However, now I would like to program the micom using the 6 pin BDM connector - How can I do that ?

Please let me know.

Regards

Pal

[peg]

Hi Pal,

Not sure what you are asking here!

Aren't you using the 6 pin connector when you programme the device from Codewarrior?

Regards

Peg

[Pal]

Hi,

I have been using USB  connector - I mean most micoms have the USB interface in which we do not need to use the 6 pin connector -

Regards

Pal

[peg]

OK, so I'm guessing you have some kind of DEMO or EVB???

Some part numbers would not go astray here you know.

Sometimes you can remove the device from the board and fit a 6 pin header, then connect this header to a similar one on another board and use the board to programme/debug another device on another board.

But this is not always the case, see other current thread re. KA2.

What exactly do you have?

Regards

Peg

[Pal]

Hi Peg,

Yaa, I am using a DEMO Board for MC9S08AW60. I want to use this micom in one of my circuits. Hence, I would like to program it using the 6 Pin BDP port so that I can create a 6 Pin interface on my new circuit board. This will then allow me to program the Micom without detaching the Micom from my circuit board.

Thanks and Regards.

Pal

[peg]

Hi Pal,

There should be no reason why this won't work with this board,

Just populate the missing 6 pin BDM port with a header and remove the AW device from the socket.

Now you have a BDM pod.

Regards

Peg

[Pal]

Well, this is really strange - It works now - Actually, there seemed to be some connection problem.

Thanks Peg.