Hi,
I configured GPIO3 to GPIO6 as digital input but UT fault bits in AN_OT_UT_FLT continue to rise (and so in FAULT1_STATUS). I tried to set temp thresholds to min/max but nothing changes. Any help?
thanks!
已解决！ 转到解答。
If no IIC used, the pack controller has to ignore the content of FAULT1_STATUS[I2C_ERR_FLT].
在原帖中查看解决方案
Hi, I've just solved AN_OT_UT_FLT bits (there was an error in the config sequence).
The only alarm I cannot disable remain I2C_ERR_FLT in FAULT1STATUS (I dont use I2C).
Is there any way to disable it?
Could you please let me know your configure steps?
