Hi,
my target is S32K144. I HAVE TWO BOARDS :
BOARD1 is a PCB representing our production board which has LIN among a whole host of other peripherals.
I've integrated the Master LIN demo in my project .using the scope I can tell I'm getting some kind of a signal consisting of breaks+sync+id+ data .
I also have a tool that shows the traffic on the bus. there is this message with ID 0X30 and DATA of 0XFD KEEPS SHOWING UP EVERY 5 MS(the rate that the LIN task runs in my code).
BOARD2 an S32k144 eval board is flashed by the LIN slave mode demo example code.
When I connect the 2 board nothing happens I'll keep getting same packet(ID 0X30 and DATA of 0XFD) as before , no LED turns on/off.
I am not a LIN expert by any means.
The LIN pins are tied together and there's a common ground.
Was wondering do I need to have Master changing some variable on its side to get something changing?
Please help.
Thanks,
Koorosh Hajiani